OLT BDCOM P3310 - First start-up

OLT BDCOM P3310 - First start-up

In a few steps we will present the process of configurating this OLT to have access to management via WWW.

First we connect the "Console" port on the OLT to the computer with an RS232 <-> RJ45 cable, supplied with OLT.

1. Select "Serial" as the connection type
2. Enter the appropriate COM port number
3. Click "Open"

When we get to OLT then we enter the following commands:

- We're going into privileged mode

Switch>enable

- We're going into configuration mode

Switch#config

- We're going into G1 interface configurations because by default all ports are down

Switch_config#interface gigaEthernet 0/1

- On port G1 we set the "no shutdown" mode

Switch_config_g0/1#no shutdown

And that's how we got the GigabiEthernet G1 port raised.

- We're leaving the G01 interface

Switch_config_g0/1#exit

- Similarly, we enter the PON1 interface configuration, because these ports are also down by default

Switch_config#interface epoN 0/1

- Set the "no shutdown" mode on the e-port 0/1.

Switch_config_epon0/1#no shutdown

And we already have the PON1 port raised.

- We're leaving the PON1 interface.

Switch_config_epon0/1#exit

- We go into VLAN interface 1 configuration - where we set the IP address

Switch_config#interface vlAN 1

- Set the IP address and the network mask

Switch_config_v1#ip address 192.168.1.100 255.255.255.0

- We leave the VLAN1 interface configuration.

Switch_config_v1#exit

- Enable http server (access via www)

Switch_config#ip http server

- Set your login and password (admin admin :)

Switch_config#aaa authentication login default local

Switch_config#aaa authentication enable default none

Switch_config#aaa authorization exec default local

Switch_config#username admin password 0 admin

Switch_config#enable password 0 admin

Switch_config#service password-encryption

- We save the configuration, because if we don't do that after the reboot the settings will be default again

Switch_config#write

Now you have to set any address from the 192.168.1.0/24 subnet on your network card.

and we already have access to OLT through a web interface.

After logging in to the device, it is recommended to update the firmware, which can be downloaded from our product page: BDCOM

Of course it is important what exactly model of BDCOM we have, because there are two types of OLTs and at the same time two types of firmware to download:

- 3310B

- 3310C

Author:

Leszek Błaszczyk